How to unclog the nozzle?

1235
2021-12-06
Adventurer 4

Method1:
Tap [Preheat], heat up the nozzle to the set temperature. Once completing heating, press the filament guide tube joint and pull out the filament guide tube. Check to see whether the filament is bent or the filament's cross-section is smooth. If not, cut it smooth, install the guide tube and filament back. Tap [Load].

Method2:
If method 1 does not work out, use an unclogging pin tool to unclog filament.

Method3:
If methods 1&2 do not work out, please replace the nozzle.